joint_state_broadcaster

The broadcaster reads all state interfaces and reports them on /joint_states and /dynamic_joint_states.

Commands

Broadcasters are not real controllers, and therefore take no commands.

Hardware interface type

By default, all available joint state interfaces are used, unless configured otherwise. In the latter case, resulting interfaces is defined by a “matrix” of interfaces defined by the cross-product of the joints and interfaces parameters. If some requested interfaces are missing, the controller will print a warning about that, but work for other interfaces. If none of the requested interface are not defined, the controller returns error on activation.

Parameters

This controller uses the generate_parameter_library to handle its parameters. The parameter definition file located in the src folder contains descriptions for all the parameters used by the controller.

List of parameters

An example parameter file

Order of the joints in the message

The order of the joints in the message can determined by 3 different parameter settings:

  1. No defined joints parameter and use_urdf_to_filter set to false:

    The order of the joints in the message is the same as the order of the joints’ state interfaces registered in the resource manager. This is typically the order in which the hardware components are loaded and configured.

  2. No defined joints parameter and use_urdf_to_filter set to true:

    The order of the joints in the message is the same as the order of the joints in the URDF file, which is inherited from the loaded URDF model and independent of the order in the ros2_control tag.

  3. Defined joints parameter along with interfaces parameter:

    The order of the joints in the message is the same as the order of the joints in the joints parameter.

    If the joints parameter is a subset of the total available joints in the URDF (or) the total available state interfaces, then only the joints in the joints parameter are published in the message.

    If any of the combinations of the defined joints parameter and interfaces parameter are not in the available state interfaces, the controller will fail to activate.

..note::

If the extra_joints parameter is set, the joints in the extra_joints parameter are appended to the end of the joint names in the message.